Farayandno

Farayandno

Simulation of hydrogen sulfide absorption tower using caustic solution and replacement of different packings to reduce caustic consumption

Document Type : Review

Authors
Ahmad Saeedi Majd 1
Izadpanah Amir Abbas 2
1 Department of Chemical Engineering, Faculty of Petroleum, Gas and Petrochemical Engineering, Persian Gulf University, Bushehr, Iran
2 Chemical engineering department, Faculty of petroleum, gas and petrochemical engineering, Persian Gulf University, Bushehr, Iran
Abstract
In this study, the selective adsorption is considered by chemical absorption by caustic aqueous solution. This study is based on the simulation with the Aspen-Plus version 9. The rate-based model has been used to determine the separation efficiency for different operating conditions in the simulation. The NRTL electrolytic model is used to describe the non-ideal behavior in liquid phase, while the Soave-Redlich-Kwong equation of state is used for vapor phase. Simulation results show the high efficiency of caustic for the removal of hydrogen sulfide. The results show that the concentration of hydrogen sulfide in the outlet gas from the absorption tower is below 0.5 ppm. It is also discussed about the replacement of different packings and their effect on the reduction of caustic consumption. The results showed that at constant caustic flow rate and concentration, FLEXIMAX-metal 400 packing had better performance in absorbing hydrogen sulfide.
Keywords
Selective Reactive Absorption
Hydrogen Sulfide
Caustic
Packed Tower
Packing

Subjects

[1]  Luo, X., et al. "Comparison and validation of simulation codes against sixteen sets of data from four different pilot plants." Energy Procedia 1.1 (2009): 1249-1256.
[2]  L ErikØi, Lars. "Comparison of Aspen HYSYS and Aspen Plus simulation of CO2 absorption into MEA from atmospheric gas." Energy Procedia 23 (2012): 360-369.
[3]  Madsen, JN. Process simulation programs for CO2 Absorption. Master Thesis, Telemark University College, 2010.
[4] Hansen, E. Aspen HYSYS and Aspen Plus simulation programs for CO2 absorption. Master Thesis, Telemark University College, 2011.
[5] I. Process, S. Engineering, and F. Ahmadi, “Assessing the Performance of Aspen Plus and Promax for the Simulation of CO2 Capture Plants,” Promax, p. 72, 2012.
[6]     م. افخمی پور، ر. آذین، ش. عصفوری، “مدل‌سازی جذب انتخابی گاز هیدروژن سولفید توسط محلول متیل دی اتانول آمین در برج جذب پرشده،” نشریه شیمی و مهندسی شیمی ایران vol. 31, no. 2, pp. 27–39, 2012.
[7] H. Cherif et al., “Experimental and simulation results for the removal of H2S from biogas by means of sodium hydroxide in structured packed columns,” World Acad. Sci. Eng. Technol. Int. J. Bioeng. Life Sci., vol. 3, no. 1, 2016.
[8] I. Applications et al., “Dynamic modelling of CO2 absorption for post combustion capture in coal-fired power plants,” vol. 88, no. 12, 2009, pp. 2455–2462.
[9]       Sanni, Samuel Eshorame, et al. "Optimization of natural gas treatment for the removal of CO2 and H2S in a novel alkaline-DEA hybrid scrubber." Egyptian Journal of Petroleum 29.1 (2020): 83-94.
 [10]   B. R. W. Pinsent, L. Pearson, and F. J. W. Roughton, “The kinetics of combination of carbon dioxide with hydroxide ions,” Trans. Faraday Soc., vol. 52, 1956, pp. 1512–1520.
[11] H. Renon and J. M. Prausnitz, “Estimation of parameters for the NRTL equation for excess Gibbs energies of strongly nonideal liquid mixtures,” Ind. Eng. Chem. Process Des. Dev., vol. 8, no. 3, 1969, pp. 413–419.
[12] G. Soave, “Equilibrium constants from a modified Redlich-Kwong equation of state,” Chem. Eng. Sci., vol. 27, no. 6, 1972, pp. 1197–1203.
[13] H. Renon and J. M. Prausnitz, “Local compositions in thermodynamic excess functions for liquid mixtures,” AIChE J., vol. 14, no. 1, 1968, pp. 135–144.
[14] R. Treybal, “Mass-transfer.” McGraw-Hill International Editions, 1981.
[15] J. Peng, S. Lextrait, T. F. Edgar, and R. B. Eldridge, “A comparison of steady-state equilibrium and rate-based models for packed reactive distillation columns,” Ind. Eng. Chem. Res., vol. 41, no. 11, 2002, pp. 2735–2744.
[16] N. Asprion, “Nonequilibrium rate-based simulation of reactive systems: simulation model, heat transfer, and influence of film discretization,” Ind. Eng. Chem. Res., vol. 45, no. 6, 2006, pp. 2054–2069.
 [17] A. Kothandaraman, Carbon dioxide capture by chemical absorption: a solvent comparison study, vol. 72, no. 1. 2010.